Project1»广场 › 技术讨论 › RPG Maker VX Ace 讨论区 › 使用药时候出了个大问题帮忙修改

使用药时候出了个大问题帮忙修改

查看数: 1735 | 评论数: 3 | 收藏 0

关灯 | 提示：支持键盘翻页<-左右->

帖子模式

lqly10

发布时间: 2015-10-28 00:15

正文摘要:

本帖最后由 lqly10 于 2015-10-29 21:03 编辑使用药时候选择给友方根本就不清楚给了谁范例：http://pan.baidu.cwjazI

lqly10 发表于 2015-10-29 21:09:46

午睡的风铃发表于 2015-10-28 14:12
这绝对是我之前瞎改脚本改出的问题(─.─|||
下面重新改了下，你测试下，把之前的那个删掉吧。
说来哥们初 ...

高手高手就是高手果然深藏不露谢谢啦有没有办法增加为8个人前面为宝宝宠物人物用混乱等状态问题都没有显示那个中了野不知道有没有办法加状态动画

lqly10 发表于 2015-10-29 21:08:27

午睡的风铃发表于 2015-10-28 14:12
这绝对是我之前瞎改脚本改出的问题(─.─|||
下面重新改了下，你测试下，把之前的那个删掉吧。
说来哥们初 ...

午睡的风铃 发表于 2015-10-28 14:12:05

本帖最后由午睡的风铃于 2015-10-28 14:14 编辑

这绝对是我之前瞎改脚本改出的问题(─.─|||
下面重新改了下，你测试下，把之前的那个删掉吧。
说来哥们初中毕业，英语考分个位数，对各种语言一窍不通，改脚本全靠脸熟= =! 如果再有问题我尽量解决。

#==============================================================================
# ■ Game_Actor
#==============================================================================
# 截图上的坐标，这部分来自你那个工程的最后一段里，可以删掉。
class Game_Actor < Game_Battler
#--------------------------------------------------------------------------
# ● 战斗者调 X 坐标。
#--------------------------------------------------------------------------
def screen_x
if self.index != nil
case self.index
when 0
return 270
when 1
return 340
when 2
return 410
when 3
return 480
end
else
return 0
end
end
#--------------------------------------------------------------------------
# ● 战斗者调 Y 坐标。
#--------------------------------------------------------------------------
def screen_y
if self.index != nil
case self.index
when 0
return 400
when 1
return 360
when 2
return 320
when 3
return 280
end
else
return 0
end
end
end
# ↑↑↑ -=-=- 以上部分请删除 -=-=-
#==============================================================================
# ■ Window_BattleStatus
#==============================================================================
class Window_BattleStatus2 < Window_Selectable
#--------------------------------------------------------------------------
# ● 初始化对象
#--------------------------------------------------------------------------
def initialize
super(0, 0, window_width, window_height)
refresh
self.opacity = 0
self.openness = 0
end
#--------------------------------------------------------------------------
# ● 获取窗口的宽度
#--------------------------------------------------------------------------
def window_width
Graphics.width - 200
end
#--------------------------------------------------------------------------
# ● 获取窗口的高度
#--------------------------------------------------------------------------
def window_height
Graphics.height + 200
end
#--------------------------------------------------------------------------
# ● 获取项目数
#--------------------------------------------------------------------------
def item_max
$game_party.battle_members.size
end
#--------------------------------------------------------------------------
# ● 刷新
#--------------------------------------------------------------------------
def refresh
contents.clear
draw_all_items
end
#--------------------------------------------------------------------------
# ● 绘制项目
#--------------------------------------------------------------------------
def draw_item(index)
actor = $game_party.battle_members[index]
draw_basic_area(basic_area_rect(index), actor)
draw_gauge_area(gauge_area_rect(index), actor)
end
#--------------------------------------------------------------------------
# ● 获取基本区域的矩形
#--------------------------------------------------------------------------
def basic_area_rect(index)
rect = item_rect_for_text(index)
rect.width -= gauge_area_width + 10
rect
end
#--------------------------------------------------------------------------
# ● 获取值槽区域的矩形
#--------------------------------------------------------------------------
def gauge_area_rect(index)
rect = item_rect_for_text(index)
rect.x += rect.width - gauge_area_width
rect.width = gauge_area_width
rect
end
#--------------------------------------------------------------------------
# ● 获取值槽区域的宽度
#--------------------------------------------------------------------------
def gauge_area_width
return 220
end
#--------------------------------------------------------------------------
# ● 绘制基本区域
#--------------------------------------------------------------------------
def draw_basic_area(rect, actor)
# 乌鸦飞过....
end
#--------------------------------------------------------------------------
# ● 绘制值槽区域
#--------------------------------------------------------------------------
def draw_gauge_area(rect, actor)
if $data_system.opt_display_tp
draw_gauge_area_with_tp(rect, actor)
else
draw_gauge_area_without_tp(rect, actor)
end
end
#--------------------------------------------------------------------------
# ● 绘制值槽区域（包括 TP）
#--------------------------------------------------------------------------
def draw_gauge_area_with_tp(rect, actor)
contents.font.size = 18
ax = actor.screen_x - 240
ay = actor.screen_y + 116
draw_text(ax, ay, 30, line_height, "HP")
draw_text(ax, ay + 16, 30, line_height, "MP")
draw_text(ax, ay + 32, 30, line_height, "TP")
draw_text(ax + 8, ay, 52, line_height, actor.hp, 2)
draw_text(ax + 8, ay + 16, 52, line_height, actor.mp, 2)
draw_text(ax + 8, ay + 32, 52, line_height, actor.tp.to_i, 2)
end
#--------------------------------------------------------------------------
# ● 绘制值槽区域（不包括 TP）
#--------------------------------------------------------------------------
def draw_gauge_area_without_tp(rect, actor)
contents.font.size = 18
ax = actor.screen_x - 240
ay = actor.screen_y + 132
draw_text(ax, ay, 30, line_height, "HP")
draw_text(ax, ay + 16, 30, line_height, "MP")
draw_text(ax + 8, ay, 52, line_height, actor.hp, 2)
draw_text(ax + 8, ay + 16, 52, line_height, actor.mp, 2)
end
end
#==============================================================================
# ■ Window_PartyCommand
#==============================================================================
class Window_PartyCommand < Window_Command
#--------------------------------------------------------------------------
# ● 初始化对象
#--------------------------------------------------------------------------
def initialize
super(388, 372)
self.openness = 0
deactivate
end
#--------------------------------------------------------------------------
# ● 获取窗口的宽度
#--------------------------------------------------------------------------
def window_width
return 96
end
#--------------------------------------------------------------------------
# ● 获取显示行数
#--------------------------------------------------------------------------
def visible_line_number
return 2
end
#--------------------------------------------------------------------------
# ● 获取对齐方式
#--------------------------------------------------------------------------
def alignment
return 1
end
end
#==============================================================================
# ■ Window_ActorCommand
#==============================================================================
class Window_ActorCommand < Window_Command
#--------------------------------------------------------------------------
# ● 获取对齐方式
#--------------------------------------------------------------------------
def alignment
return 1
end
#--------------------------------------------------------------------------
# ● 获取窗口的宽度
#--------------------------------------------------------------------------
def window_width
return 96
end
#--------------------------------------------------------------------------
# ● 设置
#--------------------------------------------------------------------------
def setup(actor)
@actor = actor
self.x = actor.screen_x - self.width / 2
self.y = actor.screen_y - 240
clear_command_list
make_command_list
refresh
select(0)
show.activate
open
end
end
#==============================================================================
# ■ Window_BattleEnemy
#==============================================================================
class Window_BattleEnemy < Window_Selectable
#--------------------------------------------------------------------------
# ● 显示窗口
#--------------------------------------------------------------------------
def show
if @info_viewport
width_remain = Graphics.width
self.x = 0
@info_viewport.rect.width = width_remain
select(0)
end
super
end
end
#==============================================================================
# ■ Window_BattleSkill
#==============================================================================
class Window_BattleSkill < Window_SkillList
#--------------------------------------------------------------------------
# ● 初始化对象
#--------------------------------------------------------------------------
def initialize(help_window, info_viewport)
y = help_window.height
super(0, y, Graphics.width, Graphics.height - help_window.height)
self.visible = false
@help_window = help_window
@info_viewport = info_viewport
end
end
#==============================================================================
# ■ Window_BattleItem
#==============================================================================
class Window_BattleItem < Window_ItemList
#--------------------------------------------------------------------------
# ● 初始化对象
#--------------------------------------------------------------------------
def initialize(help_window, info_viewport)
y = help_window.height
super(0, y, Graphics.width, Graphics.height - help_window.height)
self.visible = false
@help_window = help_window
@info_viewport = info_viewport
end
end
#==============================================================================
# ■ Scene_Battle
#==============================================================================
class Scene_Battle < Scene_Base
#--------------------------------------------------------------------------
# ● 更新信息显示的显示端口
#--------------------------------------------------------------------------
def update_info_viewport
move_info_viewport(320) if @party_command_window.active
move_info_viewport(320) if @actor_command_window.active
move_info_viewport(0) if BattleManager.in_turn?
end
#--------------------------------------------------------------------------
# ● 生成状态窗口
#--------------------------------------------------------------------------
def create_status_window
@status_window = Window_BattleStatus2.new
@status_window.x = 520
@status_window.y = -200
end
#--------------------------------------------------------------------------
# ● 生成信息显示的显示端口
#--------------------------------------------------------------------------
def create_info_viewport
@info_viewport = Viewport.new
@info_viewport.rect.y = 0
@info_viewport.rect.height = Graphics.height
@info_viewport.z = 100
@info_viewport.ox = 64
@status_window.viewport = @info_viewport
end
#--------------------------------------------------------------------------
# ● 生成队伍指令窗口
#--------------------------------------------------------------------------
def create_party_command_window
@party_command_window = Window_PartyCommand.new
px = (Graphics.width - @party_command_window.width) / 2
py = (Graphics.height - @party_command_window.height) / 2
@party_command_window.x = px
@party_command_window.y = py
@party_command_window.viewport = @viewport
@party_command_window.set_handler(:fight, method(:command_fight))
@party_command_window.set_handler(:escape, method(:command_escape))
@party_command_window.unselect
end
#--------------------------------------------------------------------------
# ● 生成角色指令窗口
#--------------------------------------------------------------------------
def create_actor_command_window
@actor_command_window = Window_ActorCommand.new
@actor_command_window.viewport = @viewport
@actor_command_window.set_handler(:attack, method(:command_attack))
@actor_command_window.set_handler(:skill, method(:command_skill))
@actor_command_window.set_handler(:guard, method(:command_guard))
@actor_command_window.set_handler(:item, method(:command_item))
@actor_command_window.set_handler(:cancel, method(:prior_command))
@actor_command_window.x = Graphics.width
end
#--------------------------------------------------------------------------
# ● 生成技能窗口
#--------------------------------------------------------------------------
def create_skill_window
@skill_window = Window_BattleSkill.new(@help_window, @info_viewport)
@skill_window.z = 200
@skill_window.set_handler(:ok, method(:on_skill_ok))
@skill_window.set_handler(:cancel, method(:on_skill_cancel))
end
#--------------------------------------------------------------------------
# ● 生成物品窗口
#--------------------------------------------------------------------------
def create_item_window
@item_window = Window_BattleItem.new(@help_window, @info_viewport)
@item_window.z = 200
@item_window.set_handler(:ok, method(:on_item_ok))
@item_window.set_handler(:cancel, method(:on_item_cancel))
end
#--------------------------------------------------------------------------
# ● 生成角色窗口
#--------------------------------------------------------------------------
def create_actor_window
@actor_window = Window_BattleActor.new(@info_viewport)
@actor_window.z = 300
@actor_window.y = Graphics.height - @actor_command_window.height
@actor_window.set_handler(:ok, method(:on_actor_ok))
@actor_window.set_handler(:cancel, method(:on_actor_cancel))
end
#--------------------------------------------------------------------------
# ● 生成敌人窗口
#--------------------------------------------------------------------------
def create_enemy_window
@enemy_window = Window_BattleEnemy.new(@info_viewport)
@enemy_window.y = Graphics.height - @enemy_window.height
@enemy_window.z = 300
@enemy_window.set_handler(:ok, method(:on_enemy_ok))
@enemy_window.set_handler(:cancel, method(:on_enemy_cancel))
end
end

复制代码

评分

参与人数 1	梦石 +1	收起理由
taroxd	+ 1	认可答案

查看全部评分

帐号		自动登录	找回密码
密码			注册会员

使用药时候出了个大问题 帮忙修改

正文摘要:

回复

评分

使用药时候出了个大问题帮忙修改